https://img.webme.com/pic/i/isacotur/728x90_banner_reklam_2.png

Hulda839623416

A Trade Must Be if The Old Auto Radio Is Damaged Or Outdated Produced

Rate this Entry
How to remove the old car radio. Before you can install the new car radio, you should remove the radio. To do so, first disconnect the battery and then proceed as follows: Remove the framework or cover from your previous automobile radio and remove the radio's user interface (if existing ).

To do so, plug in the control panel of your radio (if available) and turn on the radio. If everything works perfectly, you can install the auto radio completely. If that isn't the case, there's probably a wrong wiring. Insert the wires and test . Tip: it's best to program a radio channel. If this is no longer saved when you turn off the radio and on, probably something is wrong with all the pin assignment. If the car radio is in the ideal location, attach the cover or the framework of their new automobile radio. Already it is possible to listen to your favourite songs as you wish.

Now carefully pull on the tool. The old car radio is currently falling out of control. Slowly pull the radio out of the middle console, taking extra care not to rip any plugs. Then disconnect all links from the old radio. Don't ruin them, as they will want the cables . Take now a flat screwdriver to hand and remove the mounting frame of the old car radio in the tray. To do this, fold all of the metal tabs so you can then remove the frame.

The way to set up the new car radio. If you adored this article and you also would like to acquire more info about hilfe bei autoradios nicely visit the page. The setup of a new automobile radio isn't difficult, as long as you make sure that all connections match and the form factor (1-DIN or 2-DIN) fits. If this is not true, you may also be able to help with a suitable adapter. Here is how it works: Insert the new mounting framework. This is essential since these frames are normally not compatible with other radios. Bend the metal tabs so the frame is securely in the auto. This is especially important when you wish to make sure later on nobody can simply get rid of the car radio from your vehicle.

In Audi, VW and Opel, the pin assignment of permanent and switching plus is often reversed. For your new vehicle radio to work properly, you must alter the pin assignment. To do this, substitute the pins 4 using pin 7 on the ISO power plug. To change from the old 150 ohm antenna input, also known as DIN, to some 50 ohm ISO antenna link, you need the right adapter, such as this one for example.

For a few radios this is achieved through the antenna output. One speaks then of an energetic departure. In the event the radio doesn't have it (therefore it is"passive"), you may also use a special adapter plug in here. However, then the radio reception is poorer. If you take care of those things in advance, everything will probably be a lot easier to do later.

The hooks for the mounting clips aren't always included with the car radio. Ordinarily different pins are essential to start the holder for every maker, this serves the theft protection. If you purchased the car radio with no pins for the bracket, you can purchase them by the manufacturer. Alternately, have the auto radio installed in a workshop.

Comments